GeekIMU/2.Firmware/STM32/Firmware/stm_usb/inc/otgd_fs_pcd.h

103 lines
3.7 KiB
C
Raw Normal View History

2024-11-09 21:39:20 +08:00
/**
******************************************************************************
* @file otgd_fs_pcd.h
* @author MCD Application Team
* @version V3.4.0
* @date 29-June-2012
* @brief Header file of the High Layer device mode interface and wrapping layer
******************************************************************************
* @attention
*
* <h2><center>&copy; COPYRIGHT 2012 STMicroelectronics</center></h2>
*
* Licensed under MCD-ST Liberty SW License Agreement V2, (the "License");
* You may not use this file except in compliance with the License.
* You may obtain a copy of the License at:
*
* http://www.st.com/software_license_agreement_liberty_v2
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS,
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
* See the License for the specific language governing permissions and
* limitations under the License.
*
******************************************************************************
*/
#ifndef __USB_OTG_PCD_H__
#define __USB_OTG_PCD_H__
#include "otgd_fs_regs.h"
#define MAX_EP0_SIZE 0x40
#define MAX_PACKET_SIZE 0x400
#define USB_ENDPOINT_XFER_CONTROL 0
#define USB_ENDPOINT_XFER_ISOC 1
#define USB_ENDPOINT_XFER_BULK 2
#define USB_ENDPOINT_XFER_INT 3
#define USB_ENDPOINT_XFERTYPE_MASK 3
/********************************************************************************
ENUMERATION TYPE
********************************************************************************/
enum usb_device_speed {
USB_SPEED_UNKNOWN = 0,
USB_SPEED_LOW, USB_SPEED_FULL,
USB_SPEED_HIGH
};
/********************************************************************************
Data structure type
********************************************************************************/
typedef struct usb_ep_descriptor
{
uint8_t bLength;
uint8_t bDescriptorType;
uint8_t bEndpointAddress;
uint8_t bmAttributes;
uint16_t wMaxPacketSize;
uint8_t bInterval;
}
EP_DESCRIPTOR , *PEP_DESCRIPTOR;
/********************************************************************************
USBF LAYER UNION AND STRUCTURES
********************************************************************************/
typedef struct USB_OTG_USBF
{
USB_OTG_EP ep0;
USB_OTG_EP in_ep[ NUM_TX_FIFOS - 1];
USB_OTG_EP out_ep[ NUM_TX_FIFOS - 1];
}
USB_OTG_PCD_DEV , *USB_OTG_PCD_PDEV;
/********************************************************************************
EXPORTED FUNCTION FROM THE USB_OTG LAYER
********************************************************************************/
void PCD_Init(void);
void PCD_DevConnect (void);
void PCD_DevDisconnect (void);
void PCD_EP_SetAddress (uint8_t address);
uint32_t PCD_EP_Open(EP_DESCRIPTOR *epdesc);
uint32_t PCD_EP_Close ( uint8_t ep_addr);
uint32_t PCD_EP_Read ( uint8_t ep_addr,
uint8_t *pbuf,
uint32_t buf_len);
uint32_t PCD_EP_Write ( uint8_t ep_addr,
uint8_t *pbuf,
uint32_t buf_len);
uint32_t PCD_EP_Stall (uint8_t epnum);
uint32_t PCD_EP_ClrStall (uint8_t epnum);
uint32_t PCD_EP_Flush (uint8_t epnum);
uint32_t PCD_Handle_ISR(void);
USB_OTG_EP* PCD_GetOutEP(uint32_t ep_num) ;
USB_OTG_EP* PCD_GetInEP(uint32_t ep_num);
void PCD_EP0_OutStart(void);
#endif
/************************ (C) COPYRIGHT STMicroelectronics *****END OF FILE****/